UA Mini Plank compatible with DJI O4

This file contains the DXF, STL and PDF files for my FPV Mini Plank that can be built with or without a flight controller.  It is designed for use with the DJI O4 Air Unit.
 
Zip File Contains:
 
Airframe Components
DXF Airframe Plans
STL Airframe Templates
 
DJI Camera Mount System
DJI O4 Underslung Air Unit Mount STL
DJI O4 Camera Mount with ND filter (optional) STL
 
Paired Flight Control Horns STL
 
Foam Dart Drop System
LH Wing Mounted Servo and Foam Dart Mounts STL
RH Wing Mounted Servo and Foam Dart Mounts STL
Foam Dart Servo Fishing Line Adapter STL
 
Pusher Motor Mount (1407-3500kv) with integrated ESC carrier STL
 
Speedybee F405 Wing Mini Mount STL
 
10mm Aft Sliding Vent Latch STL
 
Notes:
The circles at the leading edge of the wing (topside) are to show alignment with the fuselage. 
 
The circles on the underside of the leading edge are to document proven center of gravity location.
 
Trim setting at takeoff should be approximately 5mm nose up trim.
 
This product is a zip archive of STL, PDF and DXF files.  No physical products - only the files. 
 
Other parts or components shown in the photos are to illustrate use.
 
Follow the videos to build the airframe.  No additional guidance as avionics, batteries and installed componenets are left to the builder.
 
Terms of Sale
This is not a license to sell, replicate or redistribute these files, parts or completed aircraft.  Personal use only.  Please contact me for commercial licensing.
 
Use at your own risk. FPV / RC can be dangerous. Be careful. No warranties for fitness or suitability for any specific purpose. I take no responsibility for any damages or injuries following the delivery of purchased files.