Simple FPV Pusher Plank STL Files

These are the 3d printed templates to cut your own Simple FPV Pusher Planks.
 
3D Print the included files, and use them to cut out parts directly, or trace them out to cut later if you prefer.  I print my templates in PLA - works fine.
 
The files are designed to print on any printer with a 200mm X 200mm print bed.
 
Included files are STL's for the following parts:
 
Airframe Components
Wing Forward Section
Wing Aft Section
Fuselage Forward Section
Fuselage Mid Section
Fuselage Aft Section
Aft Fuselage Closeout
Forward Fuselage Closeout
Motor Mount Plate
Radio Tray
Rudder
FPV Camera Mount Hatch
 
DJI Camera Mount System
Air Unit Mockup
Antenna Mockup
Carrier Pin
DJI Camera Mockup
DJI O3 Strain Relief Pin
DJI O3 Air Unit and Antenna Mount
DJI O3 Camera Mount with Top Plate
DJI O3 Air Unit Carrier Mount
 
Optional Landing Gear (for non-grass landings)
Skid Gear Mount
Landing Gear Skid
Tail Skid
 
Motor Mount for 2205-2300KV Motor with 16mm X 19mm M3 Mounts and ESC attach point
 
Speedybee F405 Wing Flight Controller Mount
 
Vent Latch
 
Battery Stop
 
Control Horns
 
Foamboard Tools
Crease Roller (Narrow)
Fold Roller (Wide)
 
Notes:
The cut out circles at the leading edge of the wing are to show alignment with the fuselage. 
 
The cut out circles on the underside of the leading edge are to document proven center of gravity location.
 
Trim setting at takeoff should be approximately 5mm nose up trim.
 
This product is a zip archive of STL files.  No physical products - only the STL files.  The other parts or components shown in the photos are to illustrate use.
 
Terms of Sale
This is not a license to sell, replicate or redistribute these files, parts or completed aircraft.  Please contact me for commercial licensing.
 
Use at your own risk. FPV / RC can be dangerous. Be careful. No warranties for fitness or suitability for any specific purpose. I take no responsibility for any damages or injuries following the delivery of purchased files.